Steps:
Get a strip of Aluminium, Then mark the metal where you want to cut it but we had to make sure that we cut it a little more than 45mm because we are going to file it down to 45mm, once you have finished cutting, try to get it as close to 45 mm as you can and try to make the sides as straight as you can once you have done that mark a line through the middle of the piece of the metal one you then drill a hole on your mark. After that we used a buffing tool that polished and made our work shiny and the final step was to imprint something into our work.
Equipment:
- File
- Engineers blue
- Engineers square
- Buffer
- Hacksaw
- Hole punch
- Hammer.
- Odd leg caliper.
- Campos.
- ruler.
- soft jaws
- Drill
This is my piece of work that I have created.
No comments:
Post a Comment
Please structure your comments as follows:
Positive - Something done well.
Thoughtful - A sentence to let us know you actually read/watched or listened to what they had to say.
Helpful - Give some ideas for next time or Ask a question you want to know more about.